Learn

Suspension data acquisition, explained by the people who build the hardware. Each guide answers one question with measurements from real runs, real screenshots of the software, and figures taken from the products rather than from a brochure. No guide states a number nobody recorded.

Browse

  • What is data acquisition in mountain biking?

    Data acquisition records what a fork and shock did on the trail at up to 1000 Hz, turning a suspension setup into a measurement instead of a guess.

    Data acquisition3 min read

  • How to read a suspension travel histogram

    A suspension travel histogram shows how much of a run the fork and shock spent at each point in their stroke, and its shape says whether the setup is right.

    Reading the data3 min read

  • Fork bottoming out: when it is normal

    When fork bottoming out is normal and when it is not: how often is too often, what a recorded run shows at the end of the stroke, and how to fix it in steps.

    Reading the data3 min read

  • How to set up mountain bike suspension

    Set up mountain bike suspension in order: sag, rebound, then compression. Sag from 15% to 30%, RockShox step sizes, and how a recorded run proves a change.

    Setup4 min read

  • How to measure sag on a mountain bike

    Measure mountain bike sag with an o-ring or a live sensor, read dynamic sag from a recorded run, and set fork and rear sag between 15% and 30% by discipline.

    Setup4 min read

  • Compression and rebound: high and low speed

    High and low speed compression and rebound explained: what each damping circuit controls, how many clicks to change, and how shaft speed data shows the effect.

    Setup3 min read

  • Hardtail vs full suspension: setup differences

    Hardtail vs full suspension setup: one fork against a fork, a rear shock and the balance between them, with sag ranges, leverage ratio and travel by discipline.

    Setup2 min read

  • How to set up e-MTB suspension

    How to set up e-MTB suspension: the same order as any mountain bike, pressures from the e-bike's own chart, and 20% fork and 30–35% shock sag in one example.

    Setup2 min read

  • Suspension tuning with data at a BYB Point

    What a suspension tuning session with data includes at a BYB Point: sensors on fork and shock, runs recorded 1000 times a second, one change at a time.

    Setup3 min read

  • How GPS lap timers work for motocross and MTB

    How GPS lap timers work for motocross and MTB: GPS-only versus trigger timing, splits, tree cover and accuracy, with Chrono's 25 Hz GPS and coded triggers.

    Hardware3 min read

  • How many lumens does a bike light need?

    How many lumens a bike light needs to see and to be seen: an 800 lm low beam lighting 80 m ahead, a 5000 lm beacon seen at 2000 m, and why beam shape matters.

    Hardware2 min read

  • How to keep a suspension setup log

    How to keep a suspension setup log that proves each change: what to record, how to file every run under its setup, and how a setup sheet does it automatically.

    Software3 min read

  • How a suspension shop gets its clients' runs

    How a suspension shop gets its clients' runs automatically: the rider's app sends each new run with bike and setup attached, filed in one profile per client.

    Software2 min read